![how to change port speed in brocade san switch how to change port speed in brocade san switch](https://lenovopress.com/assets/images/LP0582/DB610S-port-side.png)
So the first step is to get the WWPN of the HBA ports and LIFs. Members of a zone are identified by their World Wide Port Numbers(WWPN).
HOW TO CHANGE PORT SPEED IN BROCADE SAN SWITCH HOW TO
Now that you are familiar with zoning, lets look at how to create zones on a Brocade FC switch. This means you will have two zones in each switch as below. Each zone will have one host initiator and one LIF from each storage processor. The recommended configuration for implementing zoning in the fabric shown in Figure 1 is to create two zones in each switch. Zoning defines which host HBAs have access to which SPs thereby isolating and reducing the paths between the host and the LUN. Figure 1: FC SAN MultipathingįC Zoning(or just zoning) segregates and partitions a fibre channel fabric to control the access between the connected devices.
![how to change port speed in brocade san switch how to change port speed in brocade san switch](https://edgeoptic.com/wp-content/uploads/2018/09/Untitled-1.jpg)
![how to change port speed in brocade san switch how to change port speed in brocade san switch](https://www.opentechguides.com/images/howto/howto_19801.png)
The storage device has two Storage Processors and each SP has redundant connections to both FC switches. The servers have two HBA cards and are connected to two different FC switches for redundancy. The figure below shows a redundant multipath storage network with two servers. Redundancy in a storage network is achieved through a technique called multipathing where you establish multiple physical connections between the storage and the host to avoid any single point of failure.įor a fully redundant SAN network, you need to have multiple HBAs (Host Bus Adapters) in the host server that are connected to two different Storage Processors (SP) via two switches. It is called Embedded Port and it is necessary to route information between switches within one Fabric.A Storage Area Network or storage network consists of storage devices, switches and server hosts.
![how to change port speed in brocade san switch how to change port speed in brocade san switch](https://www.optcore.net/wp-content/uploads/2017/10/Brocade-300-port-side-view_s.jpg)
Of course as a consequence in Fabric every switch has always unique Domain_ID, therefore unique Domain Controller Address, therefore unique ID. Now we can actually execute the same nodefind command on switch05: switch05> nodefind 50:06:04:8a:d5:4f:23:10 And there it is – our Switch with Domain_ID=40 is switch05. This is considered as the name/ID of the switch. FFFC xx is the Address of the Domain Controller – xx represents the Domain ID. What interests us is the ID of the Switch. For that just go with the command fabricshow: switch01> fabricshow Now we have a final step – to identify which switch is it. We know the FC Address of our port, we know to which Domain it belongs and exactly to which port.